Trims

Trims settings page

Trims are used adjust the center position of a given stick axis. EdgeTX has the following time configuration options:

Reset - This resets all trim values to zero.

Trim Step: Defines the amount of increase/decrease in trim when the trim switch is pressed.

• Course = 1.6%

• Medium = 0.8%

• Fine = 0.4%

• Extra Fine = 0.2%

• Exponential = 0.2% near the center and the step value increases exponentially as the distance from the center increases.

Extended Trims: Increases the maximum trim adjustment value from ±25% to ±100%.

When switching from extended trims to normal trims, the extended trim value will remain until the trim is adjusted, then it will jump to the max/min normal trim value.

Display trims: Option to display the numerical trim value on the trim bar. Options are:

• No - Does not display the numerical trim value on the trim bar

• Yes - Displays the numerical trim value on the trim bar once the trim is no longer at zero.

• Change - Momentarily displays the numerical trim value on the trim bar (2 seconds) once the trim is no longer at zero.